[Free] 2019(Nov) EnsurePass IASSC ICBB Dumps with VCE and PDF 101-110

Get Full Version of the Exam

Question No.101

Review the analysis shown here. Which statements are true about the process? (Note:There are 3 correct answers).


  1. The initial focus for this project would be to determine why the thicknesses are so frequently too low.

  2. The majority of the process is closer to the lower specification limit.

  3. This process is described with the Weibull Distribution.

  4. The process has more problems with Variation than Centering.

  5. The process follows a non-normal distribution with the given data.

Correct Answer: BDE

Question No.102

The English words used for the 5S#39;s are Sorting, Straightening, , and Sustaining. (Note:There are 2 correct answers).

  1. Shaping

  2. Shining

  3. Standardizing

  4. Signing

Correct Answer: BC

Question No.103

Which Element of Waste best describes quot;the unnecessary movement of materials and goodsquot;?

  1. Overprocessing

  2. Inventory

  3. Motion

  4. Conveyance

Correct Answer: D

Question No.104









Using this data calculate the percentage of DPU. Data:763 defects, 18,000 units.

Correct Answer: C

Question No.105

A Belt rearranged the location of the parts inventory for a rework station locating the most often used parts to be within hand reach of the repair person. This rearrangement resulted in quicker repair times by eliminating one of seven major elements of waste which is the Waste of


  1. Motion

  2. Conveyance

  3. Inventory

  4. Waiting

Correct Answer: A

Question No.106

When variation is removed from the output of a process then the process customer can have more confidence in the experience that results from the process.

  1. True

  2. False

Correct Answer: A

Question No.107

A natural logarithmic base is not required for which of these distributions for probability calculations?

  1. Weibull

  2. Binomial

  3. Poisson

  4. Normal

Correct Answer: D

Question No.108

Which statements are correct about the advanced Capability Analysis shown here? (Note:There are 3 correct answers).


  1. This is a Poisson Capability Analysis.

  2. The average DPU with 95% confidence is between 0.024 and 0.0295.

  3. The DPU does not seem to vary depending on sample size.

  4. The process shows only one instance of being out of control statistically so we have confidence in the estimated DPU of this process.

  5. The maximum DPU in one observation was nearly 0.0753.

Correct Answer: BCE

Question No.109

Range Charts are the technique used to determine if are occurring within the subgroups of the SPC Charts.

  1. Common Causes

  2. Special inspections

  3. Unnatural forces

  4. Special Causes

Correct Answer: D

Question No.110

The Control Limits width varies if the sample size varies for which type of chart?

  1. P Charts

  2. NP Charts

  3. Xbar-R Charts

  4. Time Series Charts

Correct Answer: A

Get Full Version of the Exam
ICBB Dumps